Il mic from table of ultra-fidelity of Yaesu MD-200A8X was revealed in 2001 Dayton Hamvention. This stylish and high-quality desk microphone is designed for the latest generation of Yaesu HF transceivers. MD-200A8X employs a dynamic element of polyethylene Teraphthalate film studio-quality, optimized for high fidelity SSB operation, allowing the faithful reproduction of the voice of the operator while operating with negligible distortion. Exclusive VSPC Yaesu (lateral variable pressure control) allows the operator to adjust the frequency response of the microphone, a completely flat response to a reply of alto-articulated with moderate raising approximately 2000 hertz vertically. VSPC technique provides this control to answer without the distortion and signal-to-noise ratio reduced that can accompany active circuits "compensator". MD-200A8X also includes the provision for the incorporation of a user-supplied element of dynamic microphone, magnetic or Crystal, allowing the selection of the item element and ab dynamic supplied to order. A switch on the base of the mic allows easy switching. This mic also examination of up-down and transmits the LED which is supported via most Yaesu radio. MD-200A8X is built using a durable aluminum cast base and support structure, with a rubber damper for the housing of the mic element to damp low-frequency vibrations. Mic cable ends to a pin mic plug Yaesu 8.
Yaesu FT-817 lists these as compatible models: 840, FT-847, FT-857, FT-897 FT-900, FT-920, FT-990, FT-1000, FT-, FT-1000D, FT-1000MP, FT-DX5000, 1200 FT DX, DX 3000 FT mark v. of FT-1000MP (However, these models do not support the function of TX LEDs during broadcast: FT-840, FT-990, FT-1000D and FT-1000).