Menu
Your Cart

Remote antenna switch SPID in 8 ways

The waterproof outdoor unit is in a stainless steel housing. For the connection between the controller and the external unit 9-pin cable is required.

The controllor can be connected directly to the network. Manual switching is done simply by briefly pressing the button at the front of the controller.

The switch can handle 2000W of power up to a performing of 30MHz.

Unused antenna inputs are s mass.

This remote switch can be operated fully automatically.
To this end, the controller has two ports on the back. One is a 25-pin printer port for direct connection and PC control (automatically by the supplied software and "SPIDLog") and the other is a USB interface. This interface is not just for a PC, the switch can be controlled directly from a transceiver. In this case, the switch can be selected automatically depending on the preset band antenna port.
In addition to automatic and manual switching, the selection of connection can also be done by a mouse (included). For this reason, a separate door is provided at the back of the controller.

 

Specifications 
Frequency Range0.1 bis 30 MHz
ConnectorsPL
Power supply12 (12-24) Volt, minus on the ground
500 but
Dimensions150x150x50mm
Max Power2000 W


 

Included in delivery:

  • Switch 8:1
  • Controller
  • Centronics cabel
  • CD-ROM (Manual and Software)

Write a review

Note: HTML is not translated!
Bad Good
Captcha
We use cookies and other similar technologies to improve your browsing experience and the functionality of our site. Privacy Policy.

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.

Name
Email