Menu
Your Cart

Platforms for rotors

Heavy duty rotor platform and thrust bearing for mast up to 60 mm in diameter; diameter mast still 50-70 mm. Electroplated galvanized. Distance from center of mast to end of platform: approx. 275mm. Distance from center of mast to center of mounting position (center of rotor/bearing): approx. 195 mm.

Write a review

Note: HTML is not translated!
Bad Good
Captcha
Yaesu GS 050 thrust bearing
Top Brand
Thrust bearing for mast diameter up to 50 mm, with 4 bolts for the installation. The bearing can be used without platform with the tie rods (see photo..
42.02€
Yaesu GS 065 thrust bearing
Top Brand
Thrust bearing for mast up to 65 mm, 8 bolts, double rotating system project. For all other data show the model GS-050. Hole diameter on the base plat..
60.04€
Yaesu GC 038 rotor brackets
Top Brand
Set of brackets for YAESU rotators G-450, G650 and G-1000 These brackets are required when the rotor is installed at the top of the mast rather than o..
33.02€
Yaesu GC 048 rotor brackets
Top Brand
Set of brackets for YAESU rotators G-800 G-2700 These brackets are required when the rotor is installed at the top of the mast rather than on a platfo..
50.03€
HAM-IV with analog controlThe rotors are designed for installation on a flat surface (Rotator Platform), for installation on the top of un..
748.98€
Stainless steel screw set
Top Brand
For replacing nuts and bolts galvanically treated to the rotor mast brackets. This is a good idea and allows easy disinstallaione of the antenna, with..
13.51€
Yaesu GC 038 rotor brackets
Top Brand
Set of brackets for YAESU rotators G-450, G650 and G-1000 These brackets are required when the rotor is installed at the top of the mast rather than o..
33.02€
Yaesu GS 065 thrust bearing
Top Brand
Thrust bearing for mast up to 65 mm, 8 bolts, double rotating system project. For all other data show the model GS-050. Hole diameter on the base plat..
60.04€
PVC control cable, 6 or 8 wires, 0.75 mm ², suitable for all YAESU rotators (6 wires). Use two separate cables for the rotors for satellite (12)...
0.01€
Connectors for the control cables for the Yaesu rotators
Top Brand
Set of connectors for Yaesu 25M-WP for Yaesu rotators. A 6 pin square connector to the control unit, a 7 pin round connector with rubber cap for rotor..
36.02€
We use cookies and other similar technologies to improve your browsing experience and the functionality of our site. Privacy Policy.

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.

Name
Email