Your Cart

FlexRadio FLEX 6700

FlexRadio FLEX 6700
Only to order
FlexRadio FLEX 6700
  • Product: Only to order
  • Model: FLEX-6700
  • SKU: 454
  • EAN: 7438641843695
Ex Tax: €5,174.10

SmartSDR ª with Flex-6000 Signature Series, FlexRadio brings a wealth of new features to the amateur digital sampling including direct reception, transmission and networking. At the center of all these new features SMartSDR. SmartSDR organizes all the power of signal processing in Flex Series-6000 in a reusable framework.

Plug & Play The Flex-6000 Signature Series is designed with plug-and-play installation requirement. There are no drivers or install interface cards. Just connect the radio antenna, power and network, load the SmartSDR software on existing PC and operate.
The FLEX-6700 incorporates two independent 16-bit, Analog Devices AD9467 to synchronous 245.76 Msps (Mega samples per second) analog to digital converters (ADC), which allow direct RF spectrum scanning.
Not only receive all digital; so is the transmission. The transceiver FLEX-6700 incorporates a 16-bit AD9122 Analog Devices to digital-to-analog converter (DAC) operating at 491.52 Msps. Direct Digital Up Conversion (DUC) eliminates the traditional analog mixing and IF amplification, thus maximizing carrier and undesired sideband suppression, minimizing spurious output and intermodulation distortion in band.
The transceiver FLEX-6700 allows creating up to 8 independent Slice Receivers providing reception from 0.03 MHz to 135 MHz at 77 MHz and 165MHz. Each receiver Slice can provide independent up to 384 kHz Spectral view.
The Flex-6000 Signature Series packs more built-in digital signal process power than ever imagined in an amateur radio transceiver. The FLEX-6700 offers 317 billion operations of multiplication-addition per second (GMACS) and 121 billion floating point operations per second (GFLOPS).
The FLEX-6700 hardware FPGA transceiver uses to generate directly the waveform CW digitally with an RF carrier frequency. This means that RF carrier switches to speed hardware without truncation element as is typical in many radio.
The FLEX-6700 incorporates a low-latency audio streaming dedicated DSP parametric equalization, audio compression, gating, RF noise level adjustment, and monitoring.
A SmartSDR deserves a high performance RF power amplifier system to match. The FLEX-6500 incorporates a pair of sturdy push-pull transistor MOSFET RD100HHF operate at 13.8 V DC. It also includes an automatic antenna tuner capable of tuning out of 10:1 (3:1 on 160 m and 6 m).
The Signature Series Flex-6000 is the first family of amateur radio products offer an optional integrated GPS Disciplined oscillator (GPSDO).


  • USB 2.0 ports: 2
  • Modes: USB/LSB/CW/RTTY/AM/FM Radio
  • Antenna connector: SO-239 x 2 BNC x 1, x 2, XVTR
  • Antenna impedance: 50 Ohm unbalanced Nutrition (no tuner)
  • Requirements: + 13.8 V DC ± 15%
  • Size: 3330 x 305 x 102 mm
  • Weight: 5.44 kg
  • Wideband frequency coverage: 135-165 MHz -77 MHz 0.30
  • Amateur Band Preselector coverage: 160-6 m (except 60 m)
  • RF output power: 1-100w FM, SSB, CW, RTTY, digital; 1-30W AM
  • Amateur nominal output power band coverage: 160 m-6 m Transverter IF
  • Output power: + typical 0dBm, + 10dBm max.
  • If the transverter frequency coverage: 0.5 MHz to 150 MHz
  • Microphone connectors: 8-pin, balanced XLR/TRS unbalanced ANTENNA
  • Matching Range 80 m-10 m: 5 Ohm-500 Ohm
  • Matching Range 160 m: 16.7 Ohms-150 Ohm

Write a review

Note: HTML is not translated!
Bad Good

We use cookies and other similar technologies to improve your browsing experience and the functionality of our site. Privacy Policy.

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.