LDG IT 100 automatic tuner

LDG IT 100 automatic tuner

The tuning operation is conveniently activated by pressing a button on the tuner, using the IT-100 through the "Tune" button of the radio. A longer pressure triggers a new round of tuning, a touch short enable "bypass". Thanks to 2000 memories, the tuner is the frequencies in a very fast, for frequencies not stored, the tuner itself less than 6 seconds. The tuner fits a ROS from 10:1 (3:1 on 6 m) and therefore has a much wider range than similar models. Duel LEDs indicate the conditions of "ROS too high" and the active tuning cycle.

Both devices are connected to CAT connector or radio tuner with the supplied cable (length 35 cm), which will also provide power. Interconnessini are thus reduced to an absolute minimum. Also provides the coax (long 35 cm) to connect your tuner on the radio.

IT-100 is the successor to the tuner AT-7000, which is no longer available. It not only supports the IC-7000, but all ICOM radios with the 4-pin connector for tuner (eg: IC-706Mk2G, IC-718, IC-746, IC-7400, IC-756Pro3 etc.). The size of the tuner are 17x17x4cm, the weight is 750 g.

Further technical details:

• Operating range from 1.8 to 54.0 MHz
• from 0.1 to 125 Watts (SSB and CW), 100W on 6 m
• Time of agreement from 0.1 to 6 seconds for new frequencies, about 0.1 sec If attendance is already in memory
• Grants from 4 to 800 Ω (from 16 to 150 Ohm on 6 m), from 4 to 4:1 balun 3200 Ω with the optional
• Granting all kinds of antenna fed by coaxial cable: dipoles, verticals, directives, etc.
• The optional balun grant random long wires, wires or antennas twin ladder
• Control cable

CAUTION MANUAL IN GERMAN AND ENGLISH